The new models are available with an optional processor-controlled "duo-focus system". This means that both basic functions for guiding the light rays of operating room lamps, focusing large reflector lamps and luminous field concentration for multireflector lamps, have now been combined in a single operating room lamp.

Thus the light rays are no longer bundled over a more or less large areas, as was prebiously the case. Now, it is possible to illuminate specific points in the deepest wound channels with high-intensity light.

Instead of the conventional diffusing disk, computer-calculated, biconvex dispersing lenses are used, Together with the multi-reflector system, these increase the contrast of the operating room light and ensure a homogeneous luminous field with the lowest possible amount of showdow. Cold light filters and cold light reflectors, reduce the lamp's heat radiation to a minimum.

During development, great importance was placed on making the lamp suitable for air-conditioned ceilings. The excellent flow properties of the open ring form of all lamp housings and the minimized surface area prevent heat retention in the area of the head and furthermore produce optimum conditions for laminar flow systems.

The new previously unattainable colour rendition Ra = 96 and Rg > 92 makes it easy for you to see the tiniest nuances of colour in tissue, especially in the red and yellow range. The colour spectrum of the wound is rendered naturally and with ample contrast. This means visibly improved identification of details. This operating room lamp clearly provides welcome relief for your eyes. For further explanations, see "Technical data".

Holding the sterilizable handle with only one hand, the surgeon can set both functions, the luminous field concentration and the focus: the luminous field concentration by turning the handle (as hitherto) and the focus by turning an adjusting collar.

Focus and brightness can likewise be progressively adjusted by means of a membrane keyboard on the cardanic bows. The LED display shows the current settings for focus and brightness as well as the working distance between the wound and the operating room lamp.

Module technique ensures that all essential system components can be easily replaced. If necessary, the reflector units can be entirely replaced with the mechanical adjustment and the motors. Changing the light bulbs or updating the control pcb is just as easy.

On the pcb itself, there is an interface for a pocket computer. This allows you to call up and, if necessary, reset all essential system parameters (exact lamp voltage, traverse rate of luminous field concentration and focus, minimum dimming point, ect.).